User's Manual

ManualsBrandsAvaya ManualsIP DeskphonesAvaya Communication Server 1000 IP Phones Fundamentals

651

652

653

654

655

656

657

658

659

660

656 TFTP Server

3 When Nortel appears on the screen, press the soft keys 1,2,3,4

in sequence (left to right). BootC goes to manual configuration. If

you miss this step, and the phone begins to register to the TPS,

repeat step 1.

4 Follow the prompts to configure DHCP and other IP parameters

or, if DHCP and other parameters are already configured, just

continue pressing the 1 soft key or OK. The soft keys functions

are listed below:

•

soft key 1 (below the LCD) is OK

•

soft key 2 is Backspace

•

soft key 3 is Clear

•

soft key 4 is Cancel

5 When prompted: TFTP Dwnld? (0-No, 1-Yes):0,

• Press soft key 2 (BKSpace) to clear the 0 (No).

• Press 1 on the dialpad, then press soft key 1 (OK).

6 When prompted: TFTP IP xxx.xxx.xxx.xxx,

•

If the IP address is correct for the TFTP server, press soft key

1 (OK). After the TFTP address is entered the first time, it is

presented the next time you enter the menu.

•

If the IP address is incorrect, press soft key 2 (Clear) to erase

the address shown and enter a new address. Press the

asterisk (*) key to enter a period (.) in the IP address. You

can also use backspace key to erase part of the address or

correct errors by pressing soft key 1 (BKSpace). When the

address is correct, press soft key 1 (OK).

7 The phone reads the configuration file from the TFTP server,

extracts the Server_IP and Filename fields, and attempts

to download the file. The display shows the message [FW]

reading...

8 The display shows [FW] writing... and the blue LED starts to

flash.

9 After the FW image is written to the phone, the message [FW]

finished is displayed, the blue LED stops flashing, and the phone

resets.

The phone registers to the TPS with the new FW version.

If the TFTP Server, specified by the TFTP IP address entered

during configuration, is unreachable or down, the IP Phone

attempts to register to the TPS to perform a firmware download.

If the IP Phone does not register to the TPS, the IP Phone does

not work. Check the TFTP IP address and the state of the TFTP

Server, then reboot the IP Phone.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010