User's Manual

Updating IP Phones firmware 657
10 If the IP Phone remains in this condition because no TPS FW
download occurs, check the TFTP IP address and the state of
the TFTP Server, then restart the IP Phone.
--End--
Expansion Module for IP Phones
The Expansion Module for IP Phones 1100 Series (Expansion Module)
uses the same TFTP Server configuration file method as the IP Phones
1100 Series.
Table 147 "Fields in the TFTP configuration file for the Expansion Module"
(page 657) describes the fields in the configuration file on the TFTP
Server. The section [GEM FW] indicates the firmware is for the Expansion
Module. Set the download mode to AUTO or FORCED. It is recommended
that you set DOWNLOAD_MODE to AUTO.
Table 147
Fields in the TFTP configuration file for the Expansion Module
Field Name Field Value Descriptions
[GEM FW] Section header for the Expansion Module
firmware download information.
AUTO Recommended setting. The application looks
at the version and downloads the FW if it is a
newer version than the one on the phone.
DOWNLOAD_MODE
FORCED The version of firmware is ignored. The
firmware is always downloaded.
VERSION The version string compared to the one on the
phone.
FILENAME Image file name. This name must match the file
name of the actual IP Phone FW file.
PROTOCOL TFTP Download protocol. This must be TFTP.
SERVER_IP
xxx.xxx.xxx.xxx
IP Address of the TFTP server in decimal.
SERVER_PORT
0 to 65535
The port used by the server in which the phone
connects.
SECURITY_MODE
0
For future use.
After the IP Phone downloads the firmware from the TFTP Server, the
firmware is upgraded for any attached Expansion Modules, one at a time.
The Expansion Module verifies that the firmware was downloaded and
saved successfully before the IP Phone initiates the firmware download to
the next attached Expansion Module. If any errors occur, which prevent
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.06 30 April 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.