User's Manual

70 Nortel IP Phone 2004

2 Configure the IP Phone 2004 on the Call Server using LD 11. At

the prompt, enter the following:

REQ:new

TYPE:2004P1,2004P2

For more information about configuring the IP Phone 2004 using

LD 11, see Software Input Output Reference-Administration

(NN43001-611).

3 Configure the IP Phone 2004 in Element Manager. IP Phones

are configured using the Phones section in the Element

Manager navigation tree. For more information about configuring

the IP Phone 2004 using Element Manager, see Element

Manager System Reference - Administration (NN43001-632).

--End--

Connecting the components

Use Procedure 12 “Connecting the components” (page 70) to connect the

components for the IP Phone.

Procedure 12

Connecting the components

Step Action

1 Connect one end of the handset cord to the handset jack on the

back of the IP Phone (identified with a handset icon). See Figure

9 "IP Phone 2004 Ethernet network connections" (page 71).

2 Connect the other end of the handset cord to the handset.

3 Choose one of the following connections:

• For an IP Phone not sharing a LAN access with a PC:

Connect one end of the CAT5-e Ethernet cable to the LAN

Ethernet port located on the back of the IP Phone 2004

(identified with a LAN icon). The other end of the CAT5-e

Ethernet cable plugs into the IP network.

• For an IP Phone sharing a LAN access with a PC:

Connect one end of the CAT5-e Ethernet cable to the LAN

Ethernet port located on the back of the IP Phone (identified

with a LAN icon) and the other end to the IP network. Insert

one end of a second CAT5-e Ethernet cable into the PC

Ethernet port located on the back of the IP Phone (identified

with a PC icon) and the other end into the computer.

See Figure 9 "IP Phone 2004 Ethernet network connections"

(page 71).

The LAN Ethernet port supports Auto-Media Dependent Interface

Crossover (MDIX). Auto-MDIX is supported only when the

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010