User's Manual

Installation and configuration 71

Ethernet port is configured for autonegotiation. The PC Port

does not support Auto-MDIX.

CAUTION

Damage to Equipment

Do not plug any device into your IP Phone 2004

Ethernet port other than an IEEE 802.3 Ethernet

network connection. The IP Phone 2004 does not

support multiple devices connected through the PC

Ethernet port.

Figure 9

IP Phone 2004 Ethernet network connections

4 Connect the global power supply (optional). Leave the global

power supply unplugged from the power outlet, connect the

global power supply to the AC adapter jack in the bottom of

the phone. Form a small bend in the cable and then thread the

global power supply cord through the channels in the stand.

5 Secure the IP Phone footstand to the base of the IP Phone. Use

the angle adjustment grip on the top back of the IP Phone to

adjust the position.

6 Power the IP Phone 2004 using either the Power over Ethernet

or the global power supply (local power). If you are using local

power, plug the global power supply into the nearest power

outlet. Make sure you use the correct global power supply

supplied by Nortel and country specific IEC cable. The voltage

rating of the global power supply must match the wall outlet

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010