User's Manual

Replacing an IP Phone 2004 73

a Disable the password.

b Set the password as non-NULL.

3 Press OK when the node number displays.

If Then

the node password is enabled

and is not NULL

a password screen displays. Go

to Step 4.

the node password is disabled a TN screen displays. Go to Step

4 Enter the password at the password screen, and press OK.

A TN screen displays.

To obtain the password, enter the nodePwdShow command in

Element Manager. For further information, see

Element Manager

System Reference - Administration (NN43001-632).

5 Select the Clear soft key to clear the existing TN.

6 Enter the new TN.

--End--

Replacing an IP Phone 2004

ATTENTION

Two IP Phones cannot share the same TN. You must remove the IP Phone

2004 that currently uses the TN.

Procedure 14

Replacing an IP Phone 2004

Step Action

1 Obtain the node and TN information of the phone you want to

replace.

2 Disconnect the IP Phone 2004 that you want to replace.

3 Follow “Configuring the IP Phone 2004” (page 69) to install

the IP Phone 2004. To configure the IP Phone, see “Manual

provisioning of IP Phones 2000 Series” (page 551).

4 Enter the same TN and Node Number as the IP Phone 2004 you

replaced. The Call Server associates the new IP Phone 2004

with the existing TN.

--End--

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010