User's Manual

Installation and configuration 97

3 Configure the IP Audio Conference Phone 2033 in Element

Manager. IP Phones are configured using the Phones section

in the Element Manager navigation tree. For more information

about configuring the IP Audio Conference Phone 2033 using

Element Manager, see

Element Manager System Reference -

Administration (NN43001-632).

--End--

Connecting the components

Use Procedure 18 “Connecting the components” (page 97) to connect the

components for the IP Phone.

Procedure 18

Connecting the components

Step Action

1 Connect one end of the CAT5-e Ethernet cable to the network

interface located on the back of the Power over Ethernet (PoE)

module. See Figure 16 "POE module" (page 98). Plug the other

end of the CAT5-e Ethernet cable into your IP network interface.

2 Connect the CAT5-e Ethernet cable attached to the PoE module

to the IP Phone. Thread the CAT5-e Ethernet cable through the

channel on the bottom of the IP Phone and plug it into the PoE

module port on the IP Phone.

The PoE module port supports Auto-Media Dependent Interface

Crossover (MDIX). Auto-MDIX is supported only when the

Ethernet port is configured for autonegotiation.

3 Connect the global power supply (optional) to the power supply

port located on the back of the PoE module. Leave the global

power supply unplugged from the power outlet. Thread the cord

through the channel on the bottom of the PoE module then

plug the other end into the AC power source. Ensure you use

the correct global power supply supplied by Nortel and country

specific IEC cable. The voltage rating of the global power supply

must match the wall outlet voltage. See Table 18 "Components

list for US, CA, CALA, AP, and GC" (page 93) or Table 19

"Components list for EMEA" (page 94).

Figure 16 "POE module" (page 98) shows the Power over

Ethernet (PoE) module.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010