User's Manual

Table Of Contents

124 DECT Messenger Customer Engineer Manual

Hardware Installation

Hardware installation is described in the documentation from National

Instruments.

Software Installation

Note:

Due to subsequent software releases, the contents of this

section can differ slightly from your actual product.

The software for the I/O modules is based on the industry standard

OLE for Process Control (OPC) Server software. After you install

the software for the National Instruments modules according to the

installation procedure in

DECT Messenger Installation and Commissioning

(NN43120-301), chapter Install PC - Step 3 - National Instruments, this

OPC software is installed. The FieldPoint software is also installed,

including FieldPoint Explorer. You must set up the National Instruments

module configuration using FieldPoint Explorer, before you can use the

National Instruments module in the DECT Messenger software.

The software for the National Instruments modules consist of three main

parts.

• The eIO module that is part of the DECT Messenger software.

•

The FieldPoint Explorer software for setting up the configuration of the

FieldPoint modules.

•

OPC (Object Linking and Embedding for Process Control) Server.

Figure 37 "Software Parts for the I/O modules" (page 125) shows how

these modules are related.

Nortel Communication Server 1000

DECT Messenger Fundamentals

NN43120-120 01.06

17 October 2008