User's Manual
Table Of Contents
- New in this release
- Nortel DECT Messenger Administrator Guide
- Preface
- Nortel DECT Messenger overview
- eCONFIG
- Adding a DECT device to the Messenger system
- DECT Messenger Customer Engineer Manual
- Preface
- DECT Messenger overview
- DECT Messenger in a WAN or MAN network
- Licensing
- Detailed module descriptions
- What is required to run DECT Messenger
- DATABASES in DECT Messenger
- Installing and getting started
- Using eCONFIG
- Using eTM
- eDMSAPI Inbound
- eLOCATION
- Connecting National Instruments modules
- Understanding Security features
- Using eBackup
- Setting up e-mail integration (eSMTP_Server/eSMTP)
- Using eSMTP Server
- Using eSMTP
- Sending SMS messages
- V.24 - RS232 connections (eCAP, eESPA)
- Using Import/Export menu
- eLOG
- Checking diagnostics
132 DECT Messenger Customer Engineer Manual
Figure 39
Configuration of the Watchdog card
Note: To use the reset and automatic startup, ensure that the Reset
button signals the PC to restart, instead of signalling Windows to restart.
If the reset button signals for Windows to restart, and Task Manager is
running, Task Manager blocks the restart command.
Watchdog Installation
The following procedure describes how to install the Watchdog.
Procedure 18
Installing and connecting the Watchdog
Step Action
1 Set DIP switches.
To enable command mode and set the timer (in this example,
to 30 seconds), make the following DIP switch settings on the
Watchdog card:
SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8
OFF ON OFF OFF OFF OFF ON OFF
Note: The switches are only read at power up, and after each
time that the timer expires. A switch that is DOWN is OFF,
and a switch that is UP is ON. For more information about
these switch settings, see the Watchdog User’s Manual that
comes with the card.
2 Change the PC reset cable connection.
Nortel Communication Server 1000
DECT Messenger Fundamentals
NN43120-120 01.06
17 October 2008
Copyright © 2003–2008 Nortel Networks
.