User's Manual

309

Table: eIO_DO

eIO_DO parameters

eIODO_Site_id_n

This field specifies the site identifier, as defined in the eKERNEL_SITE

table. In most environments, this field has value 1.

An authorized of an entry typically found in this field is as follows: 1

eIODO_Area_id_n

This field specifies the area identifier, as defined in the eKERNEL_AREA

table. In most environments, this field has value 1.

An authorized of an entry typically found in this field is as follows: 1

eIODO_Module_str

This value refers to the two-byte module identifier, specified in the

FieldPoint Explorer and in eIO_MODULE table. A typical value is

between 01 and 08. Ensure that the table eIO_DO only defines digital

output-contacts, thus only the contacts with a matching digital output

module. Current release supports FP-DO-401 modules.

Current implementation of eIO is limited to configurations of up to 8

modules attached to one FP-1000 controller module. Nortel recommends

starting the first module with number 01 and incrementing by one for the

other modules. Specify the leading 0 in the numbering (do not specify 1,

but specify instead 01).

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 2

NN43120-301 02.01 4 June 2010