Quick Reference Guide

Issue 2 April 1997
41
Feature Operation
To interrupt a guest to transfer a call, do the following:
1. Transfer the call to the guest’s room number as described in the
Transfer
section on Page 49.
2. If you hear a busy tone or a Call Waiting tone, press the button.
■ You are connected to the call.
■ The people on the call may hear an intrusion tone, depending on
how the server is administered.
3. Announce the incoming call.
4. Press the button.
■ If the called station is analog, the calling person is put on Call
Waiting until the called person picks up the call.
■ If the called station is multiappearance, the calling person is
connected to an idle appearance where the called person may
pick up the call.
■ You are disconnected from the call.
■ The call appearance lamp goes off.
■ The display goes blank.
■ The
Position Available
lamp goes on.
■ The console returns to the normal operating mode.
NOTE:
You cannot use the Attendant Intrusion feature if:
■ A station is on a conference call with the maximum number of conference
parties.
■ There is one call already waiting for the called person.
■ A call is established with Data Privacy activated.
■ A station in a call is administered with Data Restriction.
Intrusn
Release