Quick Reference Guide

46
Issue 2 April 1997
Recall
Recall
The Attendant Recall feature allows callers, who are part of a conference or
two-party call being held on the console, to recall the attendant for assistance.
You should treat this as you would treat any other incoming call. Users at
single-line analog telephones must press the button or flash the
switchhook to recall the attendant. Users at multiappearance voice terminals
must press the or button to recall the attendant.
To use the Attendant Recall feature, do the following:
1. When someone requests assistance:
■ The display, such as the following, indicates that a user is
requesting assistance:
■ The
Position Available
lamp goes off.
■ The
On Hold
lamp at a call appearance button flashes.
2. To answer the recall, press the call appearance button where the
On
Hold
lamp is flashing.
■ The
On Hold
lamp goes off.
■ The call appearance lamp goes on.
■ The ringing stops.
3. To end the call, press the button.
■ You are disconnected from the call.
■ The call appearance lamp goes off.
■ The display goes blank.
■ The
Position Available
lamp goes on.
■ The console returns to the normal operating mode.
Recall
Conf Transfer
a= CONFERENCE 2 rc
Release