User's Manual

104 Software requirements
— Windows 2000 Professional or Windows 2000 Server (SP4
required)
— Windows 2003 Server (SP1 or SP2 required)
— Windows 2003 R2
— Windows XP Professional (SP2 required)
This document does not provide the steps you must follow to install the
operating system. For information about installing Windows, see the
documentation that accompanied the Windows software.
Note:
If a firewall is installed on your DAP Controller PC, ensure
the firewall does not block the ports used for different services. For
details, see “Firewall protection” (page 104).
•
Internet Explorer 6.0 or higher
•
Internet Information Services (IIS)
For information about installing IIS, see “Internet information services”
(page 105).
•
DHCP and TFTP servers
For information about installing DHCP and TFTP servers, see “DHCP
and TFTP servers” (page 111).
•
DAP Controller (IP DECT Configurator and DAP Manager)
For information about installing the DAP Controller, see “DAP
Controller” (page 130).
Firewall protection
Both Windows XP Professional and Windows 2003 Server have a built-in
firewalls.
Note:
By default, the firewall under Windows XP Professional does
not allow incoming access. However, the DAP Configurator can
automatically change the firewall settings. Verify the firewall settings
after installation.
If a third-party firewall program is installed on your DAP Controller PC,
ensure the firewall does not block the ports used for the SIP DECT
system. Some of the ports are defined by default in IP DECT Configurator.
The ports defined by default:
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 01.07
6 January 2009
Copyright © 2008-2009 Nortel Networks
.