User's Manual

Simple SIP DECT configuration 171
Configuring Universal Extension
Universal Extension (UEXT) redirects incoming calls to the DAP. Key 0
corresponds with the DN, configured on the DAP. Key 1 HOT P is the
same number with access and location codes (for UDP) or trunk steering
code (for CDP).
Use LD 11 to configure UEXT.
Note:
Packages 412 and 415 must be enabled on the Call Server.
Table 21
LD 11: Add universal extension (UDP)
Prompt Response Description
REQ NEW Add new extension
TYPE UEXT Universal Extension
CUST
n
n = customer number
TN L s c u, for
example 96 0 1
0
where L = virtual superloop, s = shelf,
c = card, u = unit
UXTY SIPN UEXT subtype
DES
aaaa
Designator. Any description can be used.
KEY 0 aaa yyyy, for
example,
0 SCR 5001
0 aaa yyyy = Primary UEXT DN, where:
• aaa = MCN, MCR, SCN, or SCR
•
yyyy = primary DN
1 HOT P nn yyyy,
for example,
1 HOT P 8
94425010
1 hot p nn yyyy = Target DN, where:
• nn = DN length (maximum length is 32)
•
yyyy = <AC1+LOC+ subscribed DN on DAP>
Table 22
LD 11: Add universal extension (CDP)
Prompt Response Description
REQ NEW Add new extension
TYPE UEXT Universal Extension
CUST
n
n = customer number
TN L s c u, for
example 96 0 1
0
where L = virtual superloop, s = shelf,
c = card, u = unit
UXTY SIPN SIPN UEXT subtype
DES
aaaa
Designator. Any description can be used.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 01.07
6 January 2009
Copyright © 2008-2009 Nortel Networks
.