User Guide

20 Chapter 3 Configuring options
NN40050-105NN40050-105
To switch between a wired headset and wireless headset:
1 Double-press the (Headset) key to open the 3. Bluetooth Setup dialog box.
2 Press the Left/Right navigation key to select the Use BT Headset item.
3 Press the Enter key to toggle this option on or off.
A check mark indicates that the wireless headset is used. Clear the check mark to use a wired
headset. On (
o) by default.
To unpair a Bluetooth wireless technology headset:
1 Double-press the (Headset) key to open the 3. Bluetooth Setup dialog box.
2 Press the Right navigation key to select the Paired: item.
3 Choose one of the following:
• If your headset is displayed in the Paired combo box, proceed to step 5.
• If more than one device is paired, and your headset is not already displayed in the Paired
combo box, do the following:
a Press the Right navigation key to select the Paired: combo box. Press the Enter key to
open edit mode.
b Press the Up/Down navigation keys to open the list. Press the Up/Down navigations key
to scroll in the list and highlight your headset.
c Press the Enter key to select the headset and close the combo box. Press the Enter key to
exit edit mode.
4 Press the Right navigation key to select the UnPair button (next to the UnPair Device item).
5 Press the Enter key.
Your wireless headset is unpaired and removed from the Paired: item's list.
2. Local Diagnostics
1. IP Set&DHCP Information
The Network Configuration tool is used to view reports about IP set and DHCP operation. This
tool is for administrator use only.
Note: Your wireless headset is no longer paired with your phone, and the
wired headset can be used. To use the wireless headset again, you must
perform the pairing and activation procedure.