$YD\D :LUHOHVV ,3 7HOHSKRQH User Guide 555-301-721 Issue 1 Part Number: 72-0064-22 Revision G July 2003
Copyright 2003, Avaya Inc. All Rights Reserved Printed in USA Notice. While reasonable efforts were made to ensure that the information in this book was complete and accurate at the time of printing, Avaya can assume no responsibility for any errors. Changes and corrections to the information contained in this document may be incorporated into future reissues. Your Responsibility for Your System’s Security.
Contents ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ Introduction Components of the Wireless IP Telephone Turn the Wireless IP Telephone on/off Basic Call Handling Answer a call Make a Call Place a second call Place the current call on hold Retrieve a held call Hang up a call Transfer a call Conference a call Mute/unmute a call Adjust the speaker volume Set the Ring Type Adjust the high noise mode setting Function Key Strokes The Function Menu Status/Tone Indicator Summary Tips For Use General Care of the Wireless Tel
Contents ii Issue 1 July 2003
Avaya 3606 Wireless IP Telephone User’s Guide Introduction This guide contains basic instructions for using and maintaining the Avaya 3606 Wireless IP Telephone. Components of the Wireless IP Telephone The following figure shows the components of the 3606 Wireless IP Telephone.
Avaya 3606 Wireless IP Telephone User’s Guide Turn the Wireless IP Telephone on/off To turn on the wireless telephone, press the PWR key. You will hear two “chirps,” indicating that the telephone is “on.” To turn off the wireless telephone, press the PWR key. You will hear one “chirp,” and the telephone turns “off.” Basic Call Handling This section describes how to make and handle calls with the wireless telephone.
Basic Call Handling Place a second call To place a second call while active on a call: 1. Press the HOLD key to place the current call on hold. 2. Press the LINE key and the digit for the line you want to use. 3. Dial the telephone number you want to call. Place the current call on hold To hold the current call, press the HOLD key. The line you placed on hold flashes. Retrieve a held call To retrieve (pick up) a held call, press the LINE key and the digit for the line on hold.
Avaya 3606 Wireless IP Telephone User’s Guide Conference a call 1. While active on the call, press the FCN key and the 4 key. The call is placed on hold, the line number for the call on hold flashes, and you hear dial tone. 2. Dial the telephone number of the person you want to add to the call. 3. Wait for the person to answer. 4. To add the person to the call, press the FCN key and the 4 key. The display shows “Conference X” (X equals number of parties on the conference, minus 1). 5.
Function Key Strokes Set the Ring Type The wireless telephone has two ring settings: Normal Ring (an audible alert) and Vibrator Ring (which only works if your wireless telephone has the optional vibrator ringer). To set the ring type: 1. Press the FCN key while the wireless telephone is on hook. 2. Press the # (right arrow) key. 3. Press 0 twice. 4. Press the # (right arrow) key to change the ring type. You can toggle from Normal ring to Vibrator ring with the # key.
Avaya 3606 Wireless IP Telephone User’s Guide You may find it useful to record the additional FCN key strokes programmed for your telephone in the table below. Table 1. Function Key Strokes Function Key Strokes Fill in Your Feature Settings FCN+1 Mute FCN+2 Last Number Dialed FCN+3 Transfer FCN+4 Conference FCN+5 FCN+6 FCN+7 FCN+8 FCN+9 FCN+0 NOTE: For example, if FCN+* corresponds to an abbreviated dialing button press START and FCN+*.
Status/Tone Indicator Summary For features that are activated by the Wireless Telephone, the corresponding function key may be pressed while the Function Menu is displaying that feature in order to activate or deactivate the feature. See your system administrator for details about features programmed into your Wireless Telephone. Status/Tone Indicator Summary The following table shows the status/tone indicators for the Wireless IP Telephone.
Avaya 3606 Wireless IP Telephone User’s Guide ■ The wireless telephone’s LCD panel displays information about the status of your wireless telephone and prompts you about features. ■ If the wireless telephone’s Battery Pack is low, you will hear a soft beep and see the “BATT” or “Low Battery” message in the display. ■ Improper disposal of Battery Packs can damage the environment. Dispose of batteries properly. ■ You can control the wireless telephone’s volume level and the type of ring.
The Wireless IP Telephone Headset Do not use any chemical cleaners. They can harm the plastic shell. If necessary, a small amount of mild surface or window cleaner can be applied to the cloth, but do not spray the cleaner onto the wireless telephone or charger. NOTE: It is recommended that standard acceptance procedures be followed prior to operating this equipment in proximity of life-support systems.
Avaya 3606 Wireless IP Telephone User’s Guide Indications of Low Battery The wireless telephone will notify you when the charge on the Battery Pack becomes low. If the wireless telephone is in use, the BATT message will display and you will hear a soft beep through the earpiece every six seconds. You have approximately two minutes to complete the call. If the wireless telephone is idle, you will hear a brief modulated ring signal and the Low Battery message will display.
The Dual Battery Charger Stand The Dual Battery Charger Stand The Dual Battery Charger Stand is a two-slot desktop charger designed to charge the Nickel Metal Hydride (NiMH) Battery Packs required to operate wireless telephones. Full charging is accomplished in approximately two hours. Only NiMH Battery Packs with a YELLOW label on the handset contact side may be charged in the Dual Battery Charger Stand. Older Battery Packs with a GREEN label will not charge.
Avaya 3606 Wireless IP Telephone User’s Guide The Battery Pack contacts may be cleaned with isopropyl (rubbing) alcohol applied with a cotton swab, cloth, or paper towel. Do not push or pull the exposed Battery Pack contacts. DO NOT POUR LIQUIDS INTO THE SLOTS. The Quick Charger The Quick Charger holds a single Battery Pack and can charge it in approximately one hour.