Operating Instructions

This device complies with Industry Canada licence-exempt RSS1
standard(s). Operation is subject to the following two conditions:2
1. This device may not cause interference, and3
2. This device must accept any interference, including4
interference that may cause undesired operation of the5
device.6
Le présent appareil est conforme aux CNR d'Industrie Canada7
applicables aux appareils radio exempts de licence. L'exploitation est8
autorisée aux deux conditions suivantes:9
1. L'appareil ne doit pas produire de brouillage, et10
2. L'utilisateur de l'appareil doit accepter tout brouillage11
radioélectrique subi, même si le brouillage est susceptible12
d'en compromettre le fonctionnement.13
Radio Transmitter Statement14
Under Industry Canada regulations, this radio transmitter may only15
operate using an antenna of a type and maximum (or lesser) gain16
approved for the transmitter by Industry Canada. To reduce potential17
radio interference to other users, the antenna type and its gain18
should be so chosen that the equivalent isotropically radiated power19
(EIRP) is not more than that necessary for successful20
communication.21
Conformément à la réglementation d'Industrie Canada, le présent22
émetteur radio peut fonctionner avec une antenne d'un type et d'un23
gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie24
Canada. Dans le but de réduire les risques de brouillage25
radioélectrique à l'intention des autres utilisateurs, il faut choisir le26
type d'antenne et son gain de sorte que la puissance isotrope27
rayonnée équivalente ne dépasse pas l'intensité nécessaire à28
l'établissement d'une communication satisfaisante.29
This Class B digital apparatus complies with Canadian ICES-003.30
Cet appareil numérique de la classe B est conforme à la norme31
NMB-003 du Canada.32
Radiation Exposure Statement33
This equipment complies with FCC & IC RSS102 radiation exposure34
limits set forth for an uncontrolled environment. This equipment35
should be installed and operated with minimum distance 20cm36
between the radiator & your body. This transmitter must not be co-37
located or operating in conjunction with any other antenna or38
transmitter.39
Cet équipement est conforme aux limites d'exposition aux40
rayonnements ISEDétablies pour un environnement non contrôlé.41
Cet équipement doit être installé et utilisé avec un minimum de 2042
cm de distance entre la source de rayonnement et votre corps.43
This product meets the applicable Innovation, Science and Economic44
Development Canada technical specifications.45
Japan Statements46
Class B Statement47
This is a Class B product based on the standard of the VCCI Council.48
If this is used near a radio or television receiver in a domestic49
environment, it may cause radio interference. Install and use the50
equipment according to the instruction manual.51
52
Denan Power Cord Statement53
Danger:
Please be careful of the following while installing the54
equipment:55
• Please only use the connecting cables, power cord, and56
AC adapters shipped with the equipment or specified by57
Avaya to be used with the equipment. If you use any58
other equipment, it may cause failures, malfunctioning,59
or fire.60
• Power cords shipped with this equipment must not be61
used with any other equipment. In case the above62
guidelines are not followed, it may lead to death or63
severe injury.64
65
本製品を安全にご使用頂くため、以下のことにご注意ください。66
• 接続ケーブル、電源コード、AC アダプタなどの部品は、必ず67
製品に同梱されております添付品または指定品をご使用くだ68
さい。添付品指定品以外の部品をご使用になると故障や動作69
不良、火災の原因となることがあります。70
• 同梱されております付属の電源コードを他の機器には使用し71
ないでください。上記注意事項を守らないと、死亡や大怪我72
など人身事故の原因となることがあります。73
México Statement74
The operation of this equipment is subject to the following two75
conditions:76
1. It is possible that this equipment or device may not cause77
harmful interference, and78
2. This equipment or device must accept any interference,79
including interference that may cause undesired operation.80
La operación de este equipo está sujeta a las siguientes dos81
condiciones:82
1. Es posible que este equipo o dispositivo no cause83
interferencia perjudicial y84
2. Este equipo o dispositivo debe aceptar cualquier85
interferencia, incluyendo la que pueda causar su operación86
no deseada.87
Brazil Statement88
Este equipamento não tem direito à proteção contra interferência89
prejudicial e não pode causar interferência em sistemas devidamente90
autorizados91
Power over Ethernet (PoE) Statement92
This equipment must be connected to PoE networks without routing93
to the outside plant.94
U.S. Federal Communications Commission (FCC) Statements95
Compliance Statement96
The changes or modifications not expressly approved by the party97
responsible for compliance could void the user’s authority to operate98
the equipment.99
To comply with the FCC RF exposure compliance requirements, this100
device and its antenna must not be co-located or operating to101
conjunction with any other antenna or transmitter.102
This device complies with part 15 of the FCC Rules. Operation is103
subject to the following two conditions:104
1. This device may not cause harmful interference, and105
2. This device must accept any interference received,106
including interferences that may cause undesired107
operation.108
This equipment has been tested and found to comply with the limits109
for a Class B digital device, pursuant to Part 15 of the FCC Rules.110
These limits are designated to provide reasonable protection against111
harmful interferences in a residential installation. This equipment112
generates, uses and can radiate radio frequency energy and, if not113
installed and used in accordance with the instructions, may cause114
harmful interference to radio communications. However, there is no115
guarantee that interference will not occur in a particular installation. If116
this equipment does cause harmful interferences to radio or117
television reception, which can be determined by turning the118