Multifunction Switch User Guide

Contents
Avaya M770 M-ACCF/SF ATM Access Modules User’s Guide iii
Setting up the M-ACC Module .............................................................. 45
Changing the Default IP Address of the M-ACC Module
Using the CLI ........................................................................................45
To connect to the M-SPX/S Console port .............................. 45
Module Setup Main Menu ..................................................................46
ATM IP Configuration ......................................................................... 46
Assigning the M-ACC module IP address, Gateway and Net-
mask: ........................................................................................... 46
Setting up the ATM Access Module .................................................. 47
Chapter 4 X-Switch CLI & ATM Terminal Interface..................................................... 49
Introduction ........................................................................................... 49
M-ACC Module Architecture .............................................................49
Conventions Used .................................................................................. 50
X-Switch Command Line Interface (CLI) .............................................. 51
Commands Summary Table ...............................................................51
To connect to the M-SPX/S Console port .............................. 51
Module Setup Main Menu ..................................................................52
Reset the Module ..................................................................................52
Software Download to the X-Switch CPU ........................................ 53
Entering Software Download Parameters ............................. 53
Starting the Software Download Process ..............................54
Monitoring the Software Download Process ........................ 54
Set Primary Version ..............................................................................55
Set Defaults to Factory Settings ..........................................................55
Create Report ........................................................................................55
Clear Mac Address Table .................................................................... 56
Configuration Copy .............................................................................56
ATM IP Configuration ......................................................................... 56
Assigning the M-ACC module IP address, Gateway and
Netmask: .....................................................................................57
ATM Access Module Terminal Interface for Configuring ATM
Parameters.............................................................................................. 58
Commands Tree Chart ......................................................................... 58
Logging On ............................................................................................58
Logging Off ........................................................................................... 59
Managing the ATM Access Module ....................................................... 59
Submenus .............................................................................................. 59
Main Menu Options .............................................................................61
Configuring System Parameters [1] ...................................................61
System Menu ..............................................................................61
Display Submenu [1,1] .............................................................62
Initialize Submenu [1,2] ............................................................ 62
Passwords Submenu [1,3] ........................................................ 62
Reset Submenu[1,4] ................................................................... 62