User Guide

Software installation
Nortel Mobile Communication Client 3100 for Nokia User Guide 19
Software installation
This section contains the following topics:
• “Installing the MCC 3100 for Nokia software from a computer”
on page 20
• “Installing the MCC 3100 for Nokia software over the air” on
page 22
• “Upgrading the MCC 3100 for Nokia software from a computer”
on page 24
• “Upgrading the MCC 3100 for Nokia software over the air” on
page 26
• “Moving the MCC 3100 for Nokia icon to the menu screen” on
page 27
• “Uninstalling the MCC 3100 for Nokia software” on page 28
• “Installing security certificates” on page 28
This section describes how to install, upgrade, and uninstall the Nortel
Multimedia Communication Client 3100 (MCC 3100) for Nokia on a
supported Nokia device. There are two ways to install or upgrade the
MCC 3100 for Nokia: from a computer or over the air.
Before you install or upgrade the MCC 3100 for Nokia software from a
computer, ensure that your Nokia device and your PC are connected
using a Universal Serial Bus (USB) cable and ensure that Nokia PC Suite
software is installed on your PC.
Note 1: Ensure that your device has the correct date and time.
Note 2: In some cases, it is necessary to remove the existing
software components prior to performing an upgrade. Check with
your system administrator or read the release notes before
proceeding with an upgrade.
Note 3: If you are upgrading from an earlier release, you must
perform an initial software installation, not an upgrade. After
reinstalling the software, change the MCG 3100 address on the