Administrator's Guide

Using ACTR to move phones
Issue 5 October 2002 103555-233-506
Call processing
When a phone is unplugged while on a call, and a 6400 Serialized phone or a 2420
phone that is administered for automatic moves is plugged into the port within 60
seconds:
■ both extensions are placed in idle state
■ active calls on either extension are dropped, unless the call is active on a
bridged appearance at some other phone
■ held calls remain in a hold state
■ any calls ringing on either extension instantly proceed to the next point in
coverage or station hunting path, unless the call is ringing on a bridged
appearance at some other phone
■ user actions that were pending when the new phone was plugged in are
aborted
Design considerations
You can use the list station movable command to keep track of extensions on the
move list. Once you reach the maximum number, the switch does not allow
additional extensions.
Administration
Before you start
■ Be sure the TTI field on the Feature-Related System Parameters screen is
set to
y.
Tasks
Before you move a phone in your system, set the TTI State field to voice on the
Feature-Related System Parameters screen.
Moving phones
You can allow a phone to be unplugged from one location and moved to a new
location without additional switch administration.
For example, to allow moves anytime for a phone at extension 1234:
1. Type
change station 1234 and press RETURN.
2. Move to the Automatic Moves field.