Administrator's Guide

Screen reference
555-233-5061046 Issue 5 October 2002
ANI for PBX
This field appears only when Outgoing Call Type is group-ii-mfc or mfe.
ANI Prefix
This field appears only when Outgoing Call Type is group-ii-mfc or mfe.
Backward Cycle Timer (sec)
Appears when the Incoming Call Type field is mfe.
Collect All Digits Before Seizure
Appears when the Outgoing Call Type is group-ii-mfc or mfe.
Valid
entries Usage
2
to 15 Enter the PBX identification number that is sent to the CO
when ANI is requested (by the CO) on a particular call but is
not available, such as on tandem tie trunk calls.
blank Use for tandeming. If this field is blank, you must enter a value
in the ANI-Not-Available field.
Valid
entries Usage
1 to 6 digits
or blank
Enter the prefix to apply to an extension when ANI is sent to
the CO.
Valid
entries Usage
1
to 255 Enter the number of seconds to wait to send the check
frequency after receiving an MFE signal.
Valid entries Usage
y
The system collects all the digits before seizing the trunk
and the ANI Req field on the AAR and ARS Digit
Conversion Table does not apply.
n Enter n to control ANI collection via the ARS screens.