Administrator's Guide

Multifrequency-Signaling-Related System Parameters
Issue 5 October 2002 1047555-233-506
Convert First Digit End-of-Dial To
Appears when the Private Group II Permissions and Public Interworking field is y.
Forward Cycle Timer (sec)
Appears when the Incoming Call Type field is mfe.
Group II Called Party Category
Appears when the Outgoing Call Type field is group-ii-mfc and the Use COR for
All Group II Responses field is
n. Enter the type of group II signals that should be
used on the outgoing R2-MFC call.
NOTE:
For India, the ANI can be requested without the Incoming Call Type
information.
Valid
entries Usage
0
to 9, #, or
blank
Enter the digit used when the incoming initial end-of-ani or
end-of-dial MF signal is converted on a per-switch basis.
Valid
entries Usage
1
to 255 Enter the number of seconds to wait to receive the check
frequency after sending an MFE signal. The switch drops the
call if the time runs out before it receives check frequency.
Valid entries Usage
user-type
The type of phone making the call determines the type of
group II signal that the PBX sends (normal = ordinary phone
set, attendant = attendant console, data-call = data modules
and similar data endpoints).
call-type
The dialed digits determine the type of group II signal that
the PBX sends.