Administrator's Guide

Screen reference
555-233-5061048 Issue 5 October 2002
This field defines the signal type that a CO uses to place an incoming call to the
PBX.
Incomplete Dial Timer (sec)
Appears when the Incoming Call Type field is mfe.
Interdigit Timer (sec)
Specify the maximum number of seconds the switch will wait for the first forward
signal (digit) to arrive, and for subsequent digits to arrive. Intercept returns to the
calling party if this timer expires.
Maintenance Call Type
Appears when the Incoming Call Type field is group-ii-mfc or non-group-ii-mfc.
Valid entries Usage
group-ii-mfc
If the value of this field is group-ii-mfc, the second page of
the screen will display entries for all group-I, group-II,
group-A, and group-B signal types with a set of default
values (see page 2 of screen).
non-group-ii-mfc
If the value is non-group-ii-mfc, the second page displays
only group-I and group-A signal types.
mfe Use only in Spain (multi-frequency Espanol)
Valid
entries Usage
45
to 255 Enter the number of seconds to wait from the start of a call
until the end of the check frequency of the last signal. The
switch drops the call if the time runs out before it receives the
check frequency.
Valid
entries Usage
1
to 255 This number must be less than the number of seconds entered
in the short interdigit timer.
Valid
entries Usage
1
The Belgium maintenance sequence is indicated when the CO
sends an MFC maintenance tone.
2
The Saudi Arabian sequence is indicated when the CO sends
an MFC maintenance tone.
none