Administrator's Guide

Multifrequency-Signaling-Related System Parameters
Issue 5 October 2002 1051555-233-506
Outgoing Start Timer (sec)
Appears when the Incoming Call Type field is mfe.
Outgoing Shuttle Exchange Cycle Timer (sec)
Appears when the Incoming Call Type field is group-ii-mfc or
non-group-ii-mfc.and the Outgoing Call Type field is group-ii-mfc or none. This
field applies only to calls made from Avaya MultiVantage.
Overlap Sending on Link-to-Link Tandem Calls
Does not appear if the Collect All Digits Before Seizure field is y. An Avaya
MultiVantage with this field set to
y, when tandeming calls between switches will
send ANI for PBX to the terminating switch if that switch requests ANI before the
Avaya MultiVantage receives it from the originating switch. The terminating
switch may request ANI before the receipt of the last address digit if it is not an
Avaya MultiVantage or it is an Avaya MultiVantage with the Request Call
Category at Start of Call field set to
y.
Private Group II Permissions and Public
Interworking
Displays when the Incoming Call Type field is group-ii-mfc or non-group-ii-mfc
and the Outgoing Call Type field is
group-ii-mfc or none.
Valid
entries Usage
1
to 255 Enter the number of seconds to time from seizure until the
beginning of the first Group A signal from the receiving end,
and from the end of the check frequency until the beginning
receipt of the first digit following the Group II signal.
Valid
entries Usage
1
to 25 Enter the number of seconds to time an exchange cycle (starts
when the far end requests a digit until Avaya MultiVantage
sends the requested digit).
Valid entries Usage
y/n
If y, Avaya MultiVantage sends and receives digits one digit
at a time instead of enbloc. (With enbloc, digits are not sent
until the entire group of digits is received).