Administrator's Guide

Route Pattern
Issue 5 October 2002 1101555-233-506
IXC
Inter-Exchange Carrier (IXC) identifies the carrier, such as AT&T, used for calls
that route via an IXC, and for Call Detail Recording (CDR).
This field appears when the ISDN-PRI or ISDN-BRI Trunks field is
y on the
System-Parameters Customer-Options screen.
LAR
Enter the routing-preference for Look Ahead Routing.
No. Del. Digits
Use this field to modify the dialed number so an AAR or ARS call routes over
different trunk groups that terminate in switches with different dial plans
Valid entries Usage
Valid carrier
code
Identifies the carrier for IXC calls
user
For presubscribed carrier. Used when an IXC is not
specified.
none
This field must be none for non-ISDN trunk groups and for
Bellcore NI-2 Operator Service Access. If you need to send
an IXC code for a non-ISDN trunk group, enter the IXC code
in the Inserted Digits field.
Valid entries Usage
next
Go to the next routing preference and attempt the call again.
rehu
Rehunt within the current routing-preference for another
trunk to attempt the call again.
none Look Ahead Routing is not enabled for the preference.
Valid entries Usage
0
to 28 or
blank
Enter the total number of digits you want the system to delete
before it sends the number out on the trunk. Use for calls that
route:
■ to or through a remote switch
■ over tie trunks to a private network switch
■ over Central Office (CO) trunks to the serving CO