Administrator's Guide

Signaling Group
Issue 5 October 2002 1123555-233-506
■ It allows you to define fractional T1 and fractional E1 facilities, specifying
how many and which channels to use.
■ It allows you to choose the port numbers to use (port numbers must be
unique for all signaling groups on the same ATM board).
The signaling channel (port 16 for an E1 and port 24 for a T1) must be a port
between
9 and 32. Any port number used on this screen may not be used on any
other ATM signaling group on the same board.
The channels used must match exactly the channels used on the other end of the
signaling group. For example, if your T1 is set up to use channels 1 through 5, 7,
and 24 (the signaling channel), the far end must use channels 1 through 5, 7, and
24.
Signaling Group screen (page 2)
Screen 259. Signaling Group screen (Administered NCA-TSC Assignment Page)
Valid
entries Usage
009
through
256 or blank
Enter the port number for non-signaling channels.
Page 2 of 5
ADMINISTERED NCA TSC ASSIGNMENT
Service/Feature: ___________ As-needed Inactivity Time-out (min):_
TSC Local Adj. Mach.
Index Ext. Enabled Established Dest. Digits Appl. Name ID
1: _____ __ _________ _____________ _______ _______ __
2: _____ __ _________ _____________ _______ _______ __
3: _____ __ _________ _____________ _______ _______ __
4: _____ __ _________ _____________ _______ _______ __
5: _____ __ _________ _____________ _______ _______ __
6: _____ __ _________ _____________ _______ _______ __
7: _____ __ _________ _____________ _______ _______ __
8: _____ __ _________ _____________ _______ _______ __
9: _____ __ _________ _____________ _______ _______ __
10: _____ __ _________ _____________ _______ _______ __
11: _____ __ _________ _____________ _______ _______ __
12: _____ __ _________ _____________ _______ _______ __
13: _____ __ _________ _____________ _______ _______ __
14: _____ __ _________ _____________ _______ _______ __
15: _____ __ _________ _____________ _______ _______ __