Administrator's Guide

Station
Issue 5 October 2002 1143555-233-506
Endpt ID
Appears only if Endpt Init is y. Enter a unique 2-digit number (00–62) for this
endpoint. Each Endpt ID field must have a unique value for each endpoint on the
same port.
This field provides for multipoint configuration conformance to the Bellcore
Terminal Initialization procedures. In these procedures, a multipoint configuration
requires the last 2 digits of the Service Profile Identifier (SPID) be between 00 and
63 and be binary unique for each endpoint. This field, combined with the SPID,
gives the effective SPID administered into the terminal. Bellcore ISDN-1 requires
the SPID programmed into the endpoint contain at least 9 digits.
For example, if the SPID is
1234, and Endpt ID is 01, then the SPID administered
on the terminal is 000123401. The three leading zeros are necessary to create a
9-digit SPID.
Endpt Init
Endpoint initialization is a procedure, required for multipoint operation, by which
User Service Order Profile (USOP) is associated with an endpoint on the
ISDN-BRI. This association is made via the SPID, administered into the system,
and entered into the ISDN-BRI terminal. For an ISDN-BRI terminal to be
operational in a multipoint configuration, both the administered SPID and the
SPID programmed into the ISDN-BRI terminal must be the same. Therefore, the
SPID of new or reused terminals must be programmed to match the administered
SPID value. Appears only if MIM Support is
y and indicates the terminal’s
endpoint initialization capability.
Expansion Module
Valid entries Usage
y
Enter y if the terminal supports Bellcore ISDN-1 terminal
initialization procedures.
n
Enter n for all other country protocols.
Valid entries Usage
y/n
Enter y if this phone has an expansion module. This will
enable you to administer the buttons for the expansion
module.