Administrator's Guide

Screen reference
555-233-5061234 Issue 5 October 2002
Screen 295. Tie Trunk Group
Analog Gain
Use this field to reduce the strength of incoming signals on TN2199 ports if users
regularly experience echo, distortion, or unpleasantly loud volume. Experiment to
find the best setting for your situation. This field appears if the Country field is
15
and the Trunk Type (in/out) field is
2-wire-ac, 2-wire-dc, or 3-wire.
Analog Loss Group
This field determines which administered 2-party row in the loss plan applies to
this trunk group if the call is carried over an analog signaling port in the trunk
group.
Valid entries Usage
a
Reduces the incoming signal by -3dB.
b Reduces the incoming signal by -6dB.
c Reduces the incoming signal by -8dB.
none No reduction. Don’t change this setting unless the trunk
group’s sound quality is unacceptable.
Valid entries Usage
1
to 17 Shows the index into the loss plan and tone plan.
add trunk-group next Page 1 of x
TRUNK GROUP
Group Number: ___ Group Type: ________ CDR Reports: _
Group Name: ___________________________ COR: __ TN: ___ TAC: ____
Direction: ________ Outgoing Display? _ Trunk Signaling Type: ____
Dial Access? _ Busy Threshold: ___ Night Service: ________
Queue Length: ___ Incoming Destination: ________
Comm Type: _____ Auth Code? _
Trunk Flash? _
BCC: _ ITC? ____
TRUNK PARAMETERS
Trunk Type (in/out): ____________ Incoming Rotary Timeout(sec): __
Outgoing Dial Type: _________ Incoming Dial Type: ________
Disconnect Timing(msec): ____
Digit Treatment: __________ Digits: ____
Sig Bit Inversion: none
Analog Loss Group: ___ Digital Loss Group: ___
Incoming Dial Tone? _
Bit Rate: _____ Synchronization: _____ Duplex: ____
Disconnect Supervision - In? _ Out? _
Answer Supervision Timeout: ___ Receive Answer Supervision? _