Administrator's Guide

Trunk Group
Issue 5 October 2002 1241555-233-506
Cut-Through
This field appears when the Outgoing Dial Type field is either rotary or tone.
!
SECURITY ALERT:
Entering y in this field will reduce your ability to prevent toll fraud.
Cyclical Hunt
When a call is offered to a trunk group, the switch searches for an available trunk.
This field, which appears when the Direction field is
two-way and the Trunk Type
field is
loop-start, controls the starting point of the search.
You can change this field from
n to y at any time. To change from y to n, however,
all the trunks in the group must be idle or busied out.
15
If the Country field is 15, Avaya MultiVantage is administered for
Public Network Call Priority (Intrusion and Rering). Also, the
Protocol Type field appears for Group Type DID or DIOD.
18
If the Country field is 18, Avaya MultiVantage can be administered
for Public Network Call Priority (Mode of Release Control, Forced
Disconnect, and Rering).
23
If the Country field is 23 and the Group Type field is either CO or
DID, Avaya MultiVantage is administered for Block Collect Calls.
Valid entries Usage
y
Enter y to allow users to get dial tone directly from the
central office. Outgoing calls over this trunk group will
bypass AAR/ARS (if you’re using it) and any of your
administered restrictions (such as COR or FRL).
n Enter n and the user will receive switch dial tone. Instead of
digits being sent to the central office, they will be collected
and checked against administered restrictions. If no
restrictions apply, the digits are sent to the central office.
Valid entries Usage
y
Enter y to have the switch start its search from the last trunk
seized. This method is faster, and thus better suited for
high-traffic trunk groups.
n
Enter n to have the switch start each search at member 1 (the
first trunk administered on the Group Member Assignments
page).
Valid entriesUsage