Administrator's Guide

Trunk Group
Issue 5 October 2002 1277555-233-506
Suppress # Outpulsing
Time (sec) to Drop Call on No Answer
This field appears if the Group Type field is co or diod and the Outgoing Dial
Type field is
mf, or if the Group Type field is co, diod, fx, wats, and the Country
field is
15.
Used for DCS
NOTE:
This field cannot be activated if the trunk group number is greater than 255
or if the Trunk Access code is more than 3-digits long.
If this field is
y, you can administer ISDN-BRI trunk groups unless the DCS
Signaling field is
d-chan. In that case, remove the BRI trunks or set the DCS
Signaling field to
bx.25 before submitting the screen.
Field descriptions for page 3
The figure below shows a common configuration for page 3 of the Trunk Group
screen when the Group Type field is
co. This screen is only an example, and the
fields shown below may change or disappear according to specific field settings.
Valid entries Usage
y/n
Enter y if end-to-end signaling begins with (and includes)
“#”. The final “#” is suppressed in cases where the system
would normally outpulse it. This field should be
y when the
Central Office (for example, rotary) or any other facility
treats “#” as an error.
Valid entries Usage
0
–1200 Enter the duration (in seconds) the switch should wait for
outgoing calls to be answered. If the call is not answered in
the specified number of seconds, the call drops. If this field
is
0, the timer is not set and no calls drop.
Valid entries Usage
y/n
Enter y if this trunk group will send and receive messages on
a DCS signaling link.