Administrator's Guide

Trunk Group
Issue 5 October 2002 1279555-233-506
Cama Outgoing Dial Guard (msec)
This field appears when Group Type is cama (the trunk group type used for
emergency 911 service).
Cama Wink Start Time (msec)
This field appears when Group Type is cama.
Disconnect Signal Error (sec)
This field appears for ground-start trunk groups.
Flash Length (msec)
This timer is sent to TN436B, TN459B, TN464C (or later), TN465B (or later),
(TN753 if Country is
23), TN2146, TN2147, TN2184, and TN2199 circuit
boards.
Valid entries Usage
25
to 6375 in
increments of
25
Enter the minimum interval between the receiving switch’s
seizure acknowledgment and the outpulsing of digits by this
switch.
Valid entries Usage
20
to 5100 in
increments of
20
Specifies the duration (the wait-for-wink-to-end time) for a
wink-start CAMA trunk. The wink must begin before the
Outgoing Seizure Response timer expires.
Valid entries Usage
1
to 255 in
increments of
1
Enter the maximum interval that the switch will wait to
receive a disconnect signal from the far-end switch after the
local party (a phone or tie trunk) goes on-hook. If the timer
expires, the system assumes a disconnect failure and take
appropriate action such as creating an error message.
Valid entries Usage
10
to 2550 in
increments of
10
Enter the duration of a flash signal generated toward the
central office.