Administrator's Guide

Trunk Group
Issue 5 October 2002 1285555-233-506
Outgoing Seizure Response (sec)
This timer is sent to the TN438B, TN439, TN447, TN458, TN464B (or later),
TN465B (or later), TN767, TN2140, TN2147, TN2184, TN2199, and TN2242
circuit packs.
Programmed Dial Pause (msec)
This timer is administrable for all outgoing and two-way trunk groups. This timer
works with the TN464B (or later), TN767, TN458, TN2140, and TN2242 tie
circuit packs. All CO circuit packs that accept administrable timers accept this
timer.
Release Ack Send (msec)
After your switch receives a forward release signal, it must send a forward release
acknowledgment signal. This field appears only if the Trunk Type field is
dis and
the trunk group Direction field is
incoming or two-way. Only TN2140 ports
receive this timer.
Valid entries Usage
1
to 255 in
increments of
1
Enter the maximum interval that the switch should wait after
sending a seizure signal to receive seizure acknowledgment
from the far-end. If the acknowledgment is not received in
this time, a seizure failure response is uplinked. For Brazil
pulsed E&M signaling, use
255.
Valid entries Usage
100
to 25500
in increments
of 100
Set the exact duration of pauses used during abbreviated
dialing, ARS outpulsing, and terminal dialing operations.
Valid entries Usage
500
to 1200
in increments
of 100
Enter the duration of the signal your switch sends for a
forward release acknowledgment.