Administrator's Guide

Screen reference
555-233-5061286 Issue 5 October 2002
Ringing Monitor (msec)
This timer is sent to TN464C (or later), TN767, TN438 (all), TN447, TN465 (all),
TN2138, TN2147, TN2184, and TN2199 CO circuit packs.
Seize Ack Delay (msec)
This field appears only if the Trunk Type field is dis and the trunk group Direction
field is
incoming or two-way. Only TN2140 ports receive this timer.
Seize Ack Send (msec)
This field appears only if the Trunk Type field is dis and the trunk group Direction
field is
incoming or two-way. Only TN2140 ports receive this timer.
Send Incoming/Outgoing Disconnect Timers to
TN465 Ports
The field appears only for a co, fx, or wats trunk group.
Valid entries Usage
200
to 51000
in increments
of 200
Enter the minimum time the switch requires to determine if a
trunk disconnects. The field cannot be blank. If the ringing
signal disappears for a duration longer than the time specified
in this field, the switch assumes the call has been
disconnected.
Valid entries Usage
40
to 120 in
increments of
10
Enter the maximum interval your switch will wait after
receipt of an incoming seizure to send seizure
acknowledgment.
Valid entries Usage
10
to 990 in
increments of
10
Enter the duration of the seizure acknowledgment signal your
switch sends in response to an incoming seizure.
Valid entries Usage
y/n
Enter y if you want to send the incoming disconnect and
outgoing disconnect timer values to the trunk group ports that
are on a TN465 board.