Administrator's Guide

Trunk Group
Issue 5 October 2002 1287555-233-506
END TO END SIGNALING
Pause (msec)
THis field is administrable only if the Trunk Type field is blank. All CO, DIOD,
and tie circuit packs that accept administrable timers accept this timer. However,
this timer is sent only to the following circuit packs: TN464B (or later), TN767,
TN436B, TN459B, TN2146, TN2199, and TN2242, and TN429 and TN2184
ports in a DID trunk group.
Tone (msec)
This field appears only if the Trunk Type field is blank. All CO, DIOD, and Tie
circuit packs that accept administrable timers accept this timer. This timer is also
sent to the following circuit packs: TN464B (or later), TN767, TN436B, TN459B,
TN2146, TN2199, TN429, TN2184 ports in a DID trunk group.
OUTPULSING INFORMATION
Break (msec)
Valid entries Usage
20
to 2550 in
increments of
10
Enter the minimum acceptable interval (pause) between
DTMF tones sent from a hybrid phone.
Valid entries Usage
20
to 2550 in
increments of
10
Enter the duration of a DTMF tone sent when a button on a
hybrid phone is pressed.
Valid entries Usage
Enter the duration of the break interval (the pulse duration) while the system is
outpulsing digits using dial pulse signaling. The field cannot be blank.
20 to 80 in
increments of
5
If PPS field is 10, the sum of the Make (msec) and Break
(msec) fields must equal 100.
10 to 40 in
increments of
5.
If the PPS field is 20, the sum of the Make (msec) and Break
(msec) fields must equal 50.