Administrator's Guide

Night Service
Issue 5 October 2002 1779555-233-506
■ Station Set Displays
When no ANI is possible, if station sets are equipped with display option,
they do not display the ANI digits. Instead, the trunk group name displays.
When ANI is possible, ANI displays on the station set.
For India Only. If ANI digits are padded with “zero,” then zeroes also are
displayed along with ANI digits.
■ Tandem / Offnet Calls
If ANI digits are received on incoming MFC calls, the ANI digits are sent
to outgoing tandem/off-net calls.
For Russia Only. The ANI is requested on incoming trunks only when all
the address digits have been collected. When the incoming trunk on a
tandem call is a Russian incoming local trunk administered to collect ANI,
the PBX collects all ANI digits before seizing the outgoing tandem trunk.
This happens even if ARS is administered with a “min” value low enough
that it would be possible to determine an outgoing route through digit
analysis.
For India Only. On an outgoing tandem-call, the default operation is to
send the ANI-Not-Available forward signal if ANI is not available from the
incoming trunk. However, in order to support this operation, leave the ANI
for PBX field blank, and define the ANI-Not-Available signal.
Related topics
For administration settings, see ‘‘Multifrequency-Signaling-Related System
Parameters’’ on page 1045.
To establish MF Signaling for a trunk group, see ‘‘Trunk Group’’ on page 1233,
(CO, DID, DIOC, TIE) - Incoming and Outgoing Dial Type.
To set up MFC ANI, see ‘‘AAR and ARS Digit Analysis Table’’ on page 577,
‘‘AAR and ARS Digit Conversion Table’’ on page 582, and ‘‘Class of
Restriction’’ on page 658.
Night Service
Avaya MultiVantage provides the following Night Service features:
■ Hunt Group Night Service
■ Night Console Service
■ Night Station Service
■ Trunk Answer from Any Station
■ Trunk Group Night Service