Administrator's Guide

Routing outgoing calls
555-233-506260 Issue 5 October 2002
Instructions
For example, we will use ARS to set up local call routing for two switch locations.
Our Chicago switch is assigned to location 1, and our New York switch is
assigned to location 2.
Our example shows a simple local dialing plan. Each location already contains
location-specific routing tables. We’ll use route pattern 1 for local service calls
and route pattern 2 for local HNPA calls in the Chicago location.
Tip:
Create location-specific routing by assigning different route patterns for
each location.
To define local calls for switches in Chicago and New York:
1. Type
change ars analysis location 1 and press ENTER.
The AAR and ARS Digit Analysis Table screen for location 1 appears.
2. Type the information for local dialed strings and service calls in each row
on the screen.
In our example, for location 1 (Chicago) local HNPA calls:
■ Type the appropriate digit in the Dialed String field
■ Type 7 in the Total Min field
■ Type 7 in the Total Max field
■ Type 2 in the Route Pattern field
■ Type hnpa in the Call Type field
change ars analysis Page 1 of X
ARS DIGIT ANALYSIS TABLE
Location: 1___ Percent Full: ___
Dialed Total Route Call Node ANI
String Min Max Pattern Type Num Reqd
2________________ 7 7 2____ hnpa ___ n
3________________ 7 7 2____ hnpa ___ n
4________________ 7 7 2____ hnpa ___ n
411______________ 3 3 1____ svcl ___ n
5________________ 7 7 2____ hnpa ___ n
555______________ 7 7 deny_ hnpa ___ n
6________________ 7 7 2____ hnpa ___ n
611______________ 3 3 1____ svcl ___ n
7________________ 7 7 2____ hnpa ___ n
8________________ 7 7 2____ hnpa ___ n
811______________ 3 3 1____ svcl ___ n
9________________ 7 7 2____ hnpa ___ n