Administrator's Guide

Setting up remote access
Issue 5 October 2002 371555-233-506
Instructions
Setting up remote access
In our example, we set up a remote access extension with maximum security. This
assists you in blocking unauthorized people from gaining access to your network.
To set up remote access:
1. Type
change remote-access and press RETURN.
The QSIG to DCS TSC Gateway screen screen appears.
2. Type
1234 in the Remote Access Extension field.
This is the extension specified in the Incoming Destination field on the CO
trunk screen.
3. Type
7 in the Barrier Code Length field.
This is the number of digits your barrier code must be when entered.
4. Type
y in the Authorization Code Required field.
This means you must also enter an authorization code when you access the
system’s Remote Access facilities. For information about setting up access
codes, see ‘‘Setting up authorization codes’’ on page 404.
5. Type
y in the Remote Access Dial Tone field.
This means you hear dial tone as a prompt to enter your authorization code.
REMOTE ACCESS
Remote Access Extension 1234___ Barrier Code Length 7__
Authorization Code Required? y Remote Access Dial Tone: y
Barrier Code COR TN COS Expiration Date No. of Calls Calls Used
1:1234567 1__ 1_ 1__ 01/01/99 ______ ______
2:________ 1__ 1_ 1__ __/__/__ ______ ______
3:________ 1__ 1_ 1__ __/__/__ ______ ______
4:________ 1__ 1_ 1__ __/__/__ ______ ______
5:________ 1__ 1_ 1__ __/__/__ ______ ______
6:________ 1__ 1_ 1__ __/__/__ ______ ______
7:________ 1__ 1_ 1__ __/__/__ ______ ______
8:________ 1__ 1_ 1__ __/__/__ ______ ______
9:________ 1__ 1_ 1__ __/__/__ ______ ______
10:_______ 1__ 1_ 1__ __/__/__ ______ ______
Permanently Disable? __ Disable Following A Security Violation? y
(NOTE: You must logoff to effect permanent disabling of Remote Access)