Administrator's Guide

Managing VAL Announcements Using FTP
Issue 5 October 2002 459555-233-506
4. Verify that there are no files listed.
NOTE:
The announcement directory on the TN2501AP or G700 Media
Gateway is
/annc.
5. Type
list integrated-annc-boards and press RETURN.
Check the list to see that the announcement was deleted. The Length in
Seconds field should show 0.
Deleting VAL announcements at a system
phone
See ‘‘Deleting and erasing announcements’’.
Managing VAL Announcements
Using FTP
This section includes information on setting up and terminating a file transfer
protocol (FTP) session and outlines tasks that you can do in an FTP session.
There are 3 basic components to an FTP session:
■ Setting up an FTP session
■ Performing tasks in an FTP session
■ Ending an FTP session
!
SECURITY ALERT:
Be sure to read and observe all of the Security Alerts regarding enabling and
disabling the VAL (TN2501AP or embedded G700 Gateway circuit packs)
filesystem and FTP sessions into it.
Setting up an FTP session
Setting up an FTP session into the VAL circuit pack involves:
1. Preparing the VAL circuit pack for the FTP session, which
■ allows an FTP session on an individual VAL circuit pack.
■ creates an ftp-login and ftp-password for that session.
2. Starting an FTP session from a computer or network management terminal.
Before you can start the FTP session, you need to know
■ the VAL circuit pack’s IP address from Step 1.
■ the VAL circuit pack’s ftp-login and ftp-password from Step 1.