Administrator's Guide

Setting up DEFINITY LAN Gateway
Issue 5 October 2002 535555-233-506
Setting up DEFINITY LAN Gateway
Before you start
This section describes pre-administrative tasks associated with the Co-Resident
DLG.
For S8100 Media Server Configurations
If you want to use a TN799 C-LAN circuit pack as the Ethernet Interface for the
Co-Resident DLG, proceed as follows:
1. Type
display system-parameters customer-options and press ENTER.
2. Go to page 2 and make sure the ASAI Link Core Capabilities and/or
Computer Telephony Adjunct Links fields are
y, and the Co-Res
DEFINITY LAN Gateway field is
y.
3. Type
display node-names ip and press ENTER.
Make sure that there is a node name associated with the C-LAN. If there is
not a node name, add one.
4. Type
display ip-interfaces and press ENTER.
Make sure the C-LAN is administered and its Ethernet port is enabled. If
the C-LAN is not listed (the Type field should display C-LAN, and the
previously administered node name should appear in the Node Name /
Local Node field), add a C-LAN.
5. Type
list data-module and press ENTER.
Make sure that the Ethernet port on the C-LAN is administered. If the
Ethernet port is not listed, add it with the
add data-module command (the
Service Type field should be
Ethernet and the Port field should be port 17
on the TN799).
If you want to use a TN2314 circuit pack as the Ethernet Interface for the
Co-Resident DLG, proceed as follows:
1. Type
display system-parameters customer-options and press ENTER.
2. Go to page 2 and make sure the ASAI Link Core Capabilities and/or
Computer Telephony Adjunct Links fields are y, and the Co-Res
DEFINITY LAN Gateway field is
y.
3. Go to page 4 and make sure that the Processor Ethernet field is
y.
4. Type
display ip-interfaces and press ENTER.