Administrator's Guide

SNMP Agents
Issue 5 October 2002 571555-233-506
For example, trumpet!g3mgt!soundblast. Notice the term ‘g3mgt’ appears
in all names.
NOTE:
If you do not use MFPM, you can enter anything but it has to be
coordinated with the receiving network management station.
NOTE:
If you are using MFPM, whatever is entered in the community string
for ‘anything’ must also be administered in MFPM. For more
information, see Avaya MultiVantage Fault and Performance
Manager, Installation and Configuration, 555-233-138.
8. In the SNMP version 2c section, check the
Check to enable SNMP
Version 2c
box.
9. In the
Community Name (read-only) field, type the same name
assigned in step 6.
10. In the
Community Name (read-write) field, type the same name
assigned in step 7.
11. In the IP Address for SNMP Access section, check the
Following IP
address
box.
12. In the
IP address 1 field, type the IP address.
The SNMP agents on this server can be programmed to accept incoming
SNMP messages from a restricted list of SNMP managers. If an SNMP
message is received from an IP address not listed, it is dropped.
13. Repeat step 12 until all IP addresses are listed.
14. Press
ENTER to save your changes.