Administrator's Guide

Screen reference
555-233-506664 Issue 5 October 2002
Forced Entry of Account Codes
FEAC must be enabled on the System Parameters Customer-Options screen and
on the CDR System Parameters screen.
See ‘‘Forced Entry of Account Codes’’ on page 1554 and ‘‘Forcing users to enter
account codes’’ on page 542 for more information.
NOTE:
If a COR requiring entry of account codes is assigned a VDN, the route to
commands executed by the associated vector will not be successful.
FRL
Valid entries Usage
y/n
Enter y to indicate that an account code must be dialed when
making outgoing trunk calls.
If this is
y, any telephone assigned the associated COR must
dial an account code before making an outgoing call. If you
set this to y for a COR assigned to a trunk group, users must
dial account codes before calling out over that trunk group.
This may be useful for trunks used in international calls, and
those that are more expensive. If a call is being routed by
ARS, account code checking is not done on the COR.
Valid entries Usage
0
to 7 Enter an originating FRL number. AAR and/or ARS features
use this entry to determine call access to an outgoing trunk
group. Outgoing call routing is determined by a comparison
of the FRLs in the AAR/ARS Routing Pattern and the FRL
associated with the COR of the call originator (typically, a
telephone user). An originating FRL of 0 has the least calling
privileges.
To enhance system security, assign the lowest possible FRL.