Administrator's Guide

Screen reference
555-233-506706 Issue 5 October 2002
The TEI identifies a unique access point within a service. You must administer
TEIs for fixed TEI terminals. However, for terminals with the automatic TEI
capability, the system dynamically assigns the TEI.
CRV Length
Appears when the Type field is
ASAI or ADJLK. Enter 1 or 2 to indicate the
length of CRV for each interface.
Field descriptions for page 2
Screen 84. Link screen when Type field is ASAI-IP or ADJ-IP
Event Minimization
May be used when event reports normally would be sent on multiple associations,
but the adjunct does not need to see more than one. Typically, these event reports
are identical except for the association they are sent over (for example, call
control, domain control, or active notification). Some applications discard
duplicate events, so in this case, there is no point in sending them across the ASAI
CTI link. When enabled, this option allows only a single such event to be sent.
The selection of the association on which the event will be sent is based on
association precedence as follows: active notification (if enabled), call control (if
enabled), or domain control (if enabled). Use the Station screen to change this
option. The new option settings take effect the next time the ASAI link is
activated.
Valid entries Usage
y/n
Entering y displays the TEI field.
For ASAI, enter
y.
Valid entries Usage
y/n
Enter y to control the behavior for that particular link.
add cti-link next Page 2 of 2
CTI LINK
FEATURE OPTIONS
Event Minimization? n Special Character for Restricted Number? n