Administrator's Guide

Dial Plan Analysis Table
Issue 5 October 2002 749555-233-506
Call Type
Valid entries Usage
attd
Attendant — Defines how users call an attendant. Attendant
access numbers can start with any number from 0 – 9 and contain
1 or 2 digits. If a telephone’s COR restricts the user from
originating calls, this user cannot access the attendant using this
code.
dac
Dial access code — Allows you to use trunk access codes (TAC)
and feature access codes (FAC) in the same range. Dial access
codes can start with any number from 0–9, * or # and can contain
up to 4 digits.
If an extension entry and a DAC entry have the same Dialed
String, the extension entry can be as long as or longer than the
DAC entry only if all of the trunk groups covered by that DAC
entry have Dial Access on the Trunk Group screen set to “no.”
You can use the DAC to activate or deactivate a switch feature or
to seize a trunk from a trunk group, or both. In the first case, the
DAC functions as a FAC, in the second as a TAC. For example,
you can define the group 300–399 for dial access codes, and
allow both FAC and TAC in that range.
You can use 4-digit DACs for ordinary trunk access, but they do
not work for attendant control of trunk groups, trunk-ID buttons,
or DCS, and only the last 3 digits of the codes can be recorded in
CDR records.
ext
Primary extension — Defines extension ranges that can be used
on your system. Extension can have a first digit of 0 through 9
and can be 1 – 7 digits in length. Extension cannot have the same
first digit as the ARS or AAR feature access code (FAC).