Administrator's Guide

Dial Plan Parameters
Issue 5 October 2002 751555-233-506
Dialed String
The dialed string contains the digits that the switch will analyze to determine how
to process the call.
Percent Full
Displays the percentage (0 to 100) of the system’s memory resources that have
been allocated for the dial plan that are currently being used.
Total Length
Dial Plan Parameters
The Dial Plan Parameters screen works with the Dial Plan Analysis Table to
define your system’s dial plan.
It also controls the appearance of 6- and 7-digit extensions on station displays and
administration forms. 6- and 7-digit extensions may be hard to read as a block.
MultiVantage allows you to select a single system-wide format for all 6-digit
extensions and a format for all 7-digit extensions.
Valid
entries Usage
0
–9, * and # Enter up to 2 characters for each call type. * and # can only be
the first digit in a string.
NOTE:
For call type attd, if the total length is 2, the Dialed
String must be 2 digits long.
Valid entries Usage
1
–2 for attd
1
–4 for dac
1
–4 for fac
1
–7 for ext
2
–6 for pext
Enter the number of digits for this call type. The allowed length
varies by call type. This must be greater than or equal to the
number of digits in the Dialed String.