Administrator's Guide

Screen reference
555-233-506956 Issue 5 October 2002
If the Group Type field is not isdn or it is isdn, but the Used for DCS field does
not appear, default is
preferred.
Path Replacement Method
Appears when either the ISDN-PRI trunk or the ISDN-BRI trunk fields and the
Basic Call Setup and Supplementary Services with Rerouting fields are set to
y on
the System-Parameters Customer-Options screen and when the Supplementary
Service Protocol is either
b or e and the Group Type field is isdn on the ISDN
trunk group screen.
Replace Restricted Numbers
Appears when the Group Type field is isdn. Indicates whether to replace
restricted numbers with administrable strings for incoming and outgoing calls
assigned to the specified trunk group. This field applies to BRI and PRI trunks.
Replace Unavailable Numbers
Appears when the Group Type field is isdn. Indicates whether to replace
unavailable numbers with administrable strings for incoming and outgoing calls
assigned to the specified trunk group. This field applies to BRI and PRI trunks.
Send Called/Busy/Connected Number
This field appears only if the QSIG Value-Added field on the Trunk Group screen
is
y and the Group Type field is isdn. Specifies if the connected party’s number is
sent on incoming or tandemed ISDN calls. Valid entries are
y, n, or r (restricted).
Valid
entries Usage
better-route
Uses the most economical route, for example, the
reconfigured call does not use the same trunk group as the
original call.
always
Always reconfigures the call regardless of the trunk group
used.
Valid
entries Usage
y/n
Enter y for the display to be replaced regardless of the service
type of the trunk.
Valid
entries Usage
y/n
Enter y for the display to be replaced regardless of the service
type of the trunk.