Installation guide

Introduction
Chapter 1
Installation Checklist 1-17
❐ Install the Server software. See “Installing BCMS Vu Server Software”
on page 4-2. Reboot the PC unless you are going to install the Client
software on the Server PC later.
❐ Install the Client software, if appropriate. See “Installing BCMS Vu
Client Software” on page 4-14. (Reboot after you install the Client
software.)
❐ Start the Server software. See “Starting BCMS Vu Server Software” in
Chapter 2 of BCMS Vu Software R2 User Guide.
❐ Set up the DEFINITY system connection. See “DEFINITY System
Connection Configuration Wizard” in Chapter 4 of BCMS Vu Software
R2 User Guide.
❐ Schedule data downloads. See “Schedule Data Download Configuration
Wizard” in Chapter 4 of BCMS Vu Software R2 User Guide.
❐ Configure Clients. See “Client Registration Configuration Wizard” in
Chapter 4 of BCMS Vu Software R2 User Guide
❐ Configure all wallboards that you will be using that are connected to
PCs on the network. Refer to “Configuring Wallboards,” page 4-10 in
BCMS Vu Software R2 User Guide.
❐ Install pcANYWHERE. See “Software Required for Maintenance
Contracts” on page 1-14.
On the Client PC 1
❐ If you are going to install external wallboards on this PC, power down
the PC.
❐ If appropriate, connect wallboards to this Client PC. Refer to “Installing
the Wallboard” on page 5-3 and to your wallboard user manual. After
you install the wallboards, turn on the PC.
Note
You do not need to install the Wallboard software on the PC
on which you have installed the Server software.