Installation manual
Table Of Contents
- Preface
- Introduction
- Administering the DEFINITY System and Configuring the Network
- Installing the Data Module, Hardware Key, and Remote Maintenance Line
- Introduction
- Installing the Data Module
- Installing a Hardware Key
- Installing a Remote Maintenance Line
- Installing and Removing BCMS Vu Software
- Installing a Wallboard
- Troubleshooting Problems
Installing and Removing BCMS Vu Software
4-30 Installing BCMS Vu Wallboard Software
Installing BCMS Vu Wallboard Software 4
To start the BCMS Vu Wallboard software installation setup program,
complete the following steps:
1. Close all running programs on this PC.
2. Load the BCMS Vu software distribution CD-ROM into the drive.
Note
Installing Wallboard software is not the same as registering
(also called “Configuring”) a wallboard. Wallboard software
permits a user to send a report or message to a wallboard.
Registering a wallboard involves telling BCMS Vu Server the
location and specifications of wallboards connected to PCs
on the network.
Note
It is not necessary to install the wallboard software on the
same PC as BCMS Vu Server software; Server software
includes Wallboard software. However, you must install
Wallboard software on every other PC to which a wallboard
that is registered with the Server is physically connected.
Note
If you choose to install BCMS Vu Wallboard after you installed
BCMS Vu Client, and you did not re-boot your PC, but instead
selected “Setup BCMS Vu Wallboard” in the “BCMS Vu R2 Master
Setup” window, go to “Welcome” on page 4-32.