Installation manual
Table Of Contents
- Preface
- Introduction
- Administering the DEFINITY System and Configuring the Network
- Installing the Data Module, Hardware Key, and Remote Maintenance Line
- Introduction
- Installing the Data Module
- Installing a Hardware Key
- Installing a Remote Maintenance Line
- Installing and Removing BCMS Vu Software
- Installing a Wallboard
- Troubleshooting Problems
Introduction
1-6 Overview of the Installation
Overview of the Installation 1
The steps to complete the installation and setup of BCMS Vu Software R2
are:
1. Administer the DEFINITY system.
2. Administer the network or stand-alone PC, if any.
3. Install the data module.
4. Install the hardware key on the Server PC.
5. Install the BCMS Vu Server software.
6. Install the BCMS Vu Client software.
7. Install the BCMS Vu Wallboard software if you are using wallboards.
8. Install the wallboard(s) if you are using any.
9. Configure BCMS Vu software.
10. Verify connectivity to the DEFINITY system.
11. Verify that acceptance criteria have been met.
The remaining chapters of the guide describe these steps.