Installation manual
Table Of Contents
- Preface
- Introduction
- Administering the DEFINITY System and Configuring the Network
- Installing the Data Module, Hardware Key, and Remote Maintenance Line
- Introduction
- Installing the Data Module
- Installing a Hardware Key
- Installing a Remote Maintenance Line
- Installing and Removing BCMS Vu Software
- Installing a Wallboard
- Troubleshooting Problems
Administering the DEFINITY System and Configuring the Network
2-10 Administering the DEFINITY System
Netcon Channels for DEFINITY G3SI or ProLogix
System Ports for DEFINITY G3r
2
If the DEFINITY system is a G3SI or ProLogix, you must administer netcon
channels. If the DEFINITY system is a G3R, you must administer system
ports. The netcon channels or system ports are also administered as
members of a hunt group.
To determine if a hunt group has been administered, issue the following
command:
list hunt-group
If you find a hunt-group with the name “netcon” or “system ports,” record
the group extension number being used. You will use this later to configure
BCMS Vu. The hunt group number, extension, and members are determined
locally by the account team or customer.
display hunt-group 20 Page 1 of 10
HUNT GROUP
Group Name: netcon or system ports
Group Number: 20 Group Extension: 2199 Group Type: ucd
MM Early Answer? n Skill? n ACD?n
Queue? n Vector? n
Security Code: Night Service Destination: COR: 1
ISDN Caller Disp: Coverage Path: TN: 1