User's Manual

5. After the antennas are put in the vertical position, replace the 4720 DAP

cover and

secure the screws at the rear side of the cabinet.

Figure 44: Antennas locked into Cover

6. Ensure that the antennas are properly locked into the locks in the 4720 DAP

cover,

as shown in

Figure 45: Antenna in locked position on page 179.

Figure 45: Antenna in locked position

7. Move the antenna cover carefully over the antennas in the vertical position and

make sure that the antennas do not bend. When the antenna cover is in place,

attach it by pushing it into its position in the 4720 DAP cabinet.

Figure 46: Cover installed

The 4720 DAP is now ready to install.

Adjusting the antenna position

SIP DECT Fundamentals October 2012 179