User's Manual

The default value is YES if not specified in the device configuration file. If SIP_PING is
changed in the Device configuration file, the IP Deskphone must be rebooted for the
change to take effect.
- YES - enables pinging
- NO - disables pinging
• IPV6_ENABLE [YES] [NO] — This parameter must be applied at boot time prior to the
network being enabled. The default value is NO. When this parameter is enabled, IPv4/
IPv6 are supported on the IP Deskphone. When this parameter is not enabled only IPv4
is supported on the IP Deskphone.
- YES – enables IPv6 functionality in a dual mode
- NO – disables IPv6 functionality (default)
When the protocol is changed, the IP Deskphone automatically restarts and updates the
Device Settings on the IP Deskphone.
• FAIL_BACK_TO_PRIMARY [YES | NO] — This parameter allows you to enable/disable
the Fail Back to Primary feature.
- YES - enables the fail back.
- NO - disables the fail back (default).
• CACHED_IP_ENABLED [YES | NO] — This parameter configures the cached IP feature.
The parameter defines whether the IP Deskphone uses the IP address information
previously configured if the IP Deskphone is not able to reach DHCP server or if it should
interrupt regular work and wait for a DHCP response. The default is NO.
- YES — the last IP address information is used if the DHCP server is not reached.
- NO — Must receive a response to assign the IP Deskphone an IP address
(default).
• PCPORT_ENABLE [YES | NO] — This parameter enables/disables the PC port. The
default is YES.
- YES — PC port is active (default).
- NO — PC port is disabled.
• LLDP_ENABLE [YES | NO] —
- YES – 802.1ab (LLDP) is enabled.
- NO – 802.1ab (LLDP) is disabled (default).
• HTTP_RETRY_NUMBER [x] — This parameter configures the number of times the IP
Deskphone attempts to contact the server when an HTTP 503 (server is unavailable)
response is received. The IP Deskphone stops trying to connect to the server after
HTTP_RETRY_NUMBER unsuccessful attempts have been made, or if any other
response except HTTP 503 is received from the server.
x = positive integer. The default is 5.
Create the device configuration file
SIP Software for Avaya 1200 Series IP Deskphones-Administration September 2013 53